Thursday, December 15, 2011

Stolen from Rockler Blog

I totally ripped this off from Rockler's blog, but it sounds like something I would totally do if I didn't have a kitchenaid mixer alread!

A Router Technique We Can't Endorse

This tale of router "technique" turned culinary disaster appeared a few years ago onrec.woodworking and later found its way to the Woodworker's Journal eZine Web Surfers' Review.   We think the story is so well and vividly told that it deserves to be posted again.
"This afternoon I was foolishly left alone in the kitchen with a seemingly simple task: whip some cream.
It all started when I was attempting to whip some whipping cream into, oddly enough, whipped cream with a hand whisk, and it seemed to require far too much effort on my part. I am sure a Neanderthal would be quite happy with a hand whisk, but I was looking for a Normite way to get this done. Now I realize that most people have a power hand mixer, or what ever they are called, but I don't have one.
I started thinking, how much different could one of those things be from a router? All a hand mixer consists of is a motor with a Jacobs chuck- like socket for whisks. Now if you think you know where I am going with this, you are probably correct. I got out the dial calipers and the shaft of the hand whisk was exactly 1/4". Woo Whoo!my first problem was solved. I could use the standard 1/2" to 1/4" bushing. I go out to the shop and take my 3 1/4 HP Hitachi M12V out of the router table and go back into the kitchen. Using my 21mm and custom ground thin 23mm Craftsman wrenches, I chuck up the whisk. Next problem: speed. I measured the diameter of the business end of the whisk and consulted my router bit speed chart. It said I should use 18,000 RPM. The only question left was technique, clockwise or counter clockwise.
Since I was doing an inside cut, I decided to use the standard counter clockwise. I fired up the big green monster. Good thing the M12V has a soft start feature, because even with my elbows braced on the countertop, this is a heavy and unwieldy router to freehand in the air. Even then the torque was still more than I was prepared for and I almost lost it. OK, here we are, full power. There was a quick blur of chaotic white liquid filling the air, and as the blur subsided I quickly realized the bowl that previously held two cups of whipping cream was now virtually devoid of cream. I powered down the router. My face, glasses and upper body were covered in cream, as was two thirds of the kitchen. My better half, alerted by the unusual tool noise and loud cursing coming from the kitchen, walks in to ask just what the hell I thought I was doing. I wipe off, change clothes and come back to explain myself and clean up a very large mess.
Once I explained what I was attempting to the young lady, I thought she was about to become my ex-wife. She was standing in front of me with a look of such total disbelief. I was told that 18,000 rpm was a little too high for a whisk, and that a variable speed cordless drill would have been the correct choice of tool for this task. We were out of whipping cream at this point, so I will have to wait until after I have a chance to go to the store tomorrow to find out if the cordless drill works any better. Now that I think about it, it would seem like the drill press is the way to go."
We can't say for certain whether any of the routers that Rockler offers have been "kitchen tested" and found suitable for the operation described above. But we can say, without fear of contradiction, that Rockler offers one of the best and most complete selections of routersrouter bits androuter accessories that you'll find anywhere.

1 comment:

  1. Very Nice Blog, I am very happy to visit yours blog. Keep up the good work. I wait to read more posts.
    Pilot license